Fire Door Hinges: Why Certified Hinges Are Non-Negotiable

Fire Door Hinges: Why Certified Hinges Are Non-Negotiable

The average fire door weighs 35–50kg. Add the dynamic load of being slammed shut by a closer thousands of times a year — plus the demand to perform under fire conditions — and it's easy to see why hinges are one of the most heavily regulated components.

The Standard: BS EN 1935

All hinges fitted to UK fire doors must conform to BS EN 1935:2002 and carry CE or UKCA marking with classification code Grade 13 for fire doors. The classification covers:

  • Category of use (4 = severe, suitable for public buildings)
  • Durability (200,000 test cycles minimum)
  • Test door mass (up to 120kg)
  • Fire resistance (suitable for use on fire/smoke door assemblies)
  • Safety (for safety in use)
  • Corrosion resistance

If your hinges don't carry visible CE/UKCA marking and a manufacturer reference, they fail inspection automatically.

How Many Hinges?

The default specification is three hinges per fire door:

  • Top hinge — 250mm from top of door
  • Centre hinge — at midpoint
  • Bottom hinge — 250mm from bottom

Heavier doors (FD60, oversized leaves) may require a fourth hinge — check the original door certification or your pre-hung doorset specification.

Intumescent Hinge Pads

Hinges are mortised into the door leaf, removing structural timber. To protect this weakened area in a fire, intumescent hinge pads must be fitted between the hinge and the timber on both the leaf and the frame.

These pads expand under heat to fill the void and maintain the door's fire rating. Missing pads are an automatic failure — and yes, inspectors do remove a hinge to check.

Common Hinge Defects

  • Wrong hinge type — domestic-grade hinges fitted to fire doors
  • Missing intumescent pads — often forgotten on retrofit jobs
  • Loose or missing screws — full-thread, correct-length screws required
  • Bent leaves — caused by overweight doors or vandalism
  • Painted-over CE markings — making certification impossible to verify

For a full breakdown of common defects, see our survey checklist guide.

The Screw Question

Often overlooked: hinges must be fixed with steel screws of the correct length to penetrate fully into the frame substrate. Short screws, brass screws, or missing screws all void compliance.

Our installation team uses a documented hinge schedule on every job — so you have proof of compliance from day one.

Don't Compromise on Ironmongery

Hinges are not the place to save money. The cost difference between domestic and certified Grade 13 hinges is often less than £15 per door — but the legal and safety difference is enormous.

Book an inspection to verify your hinge compliance, or call 01522 775570 to discuss replacement.