Fire Door Gap Requirements UK: What Are the Correct Tolerances?

Fire Door Gap Requirements UK: Correct Tolerances Explained

Excessive gaps are the number one defect we find during fire door inspections across Lincoln, Nottingham, Sheffield and the East Midlands. Getting gaps right is critical to fire door performance.

What Are the Correct Gap Tolerances?

According to BS 8214:2026 (the British Standard for fire-resisting and smoke control doors):

| Gap Location | Maximum Gap | Notes | |---|---|---| | Top of door | 3mm ±1mm | Maximum 4mm | | Sides of door (hinge & latch) | 3mm ±1mm | Maximum 4mm | | Meeting stiles (double doors) | 3mm ±1mm | Maximum 4mm | | Bottom of door | Up to 8mm* | *Or as specified by manufacturer/fire test | | Threshold with intumescent seal | Up to 3mm | When threshold seal is fitted |

Why Gaps Matter

In a fire:

  • Gaps allow smoke to pass through — smoke kills more people than flames
  • Gaps prevent intumescent strips from sealing effectively
  • Gaps compromise the door's tested fire resistance period

A door with 6mm side gaps may provide significantly less than its rated 30 or 60 minutes of fire resistance.

How to Measure Fire Door Gaps

Use a tapered gap gauge (available from fire safety suppliers):

  1. Insert the gauge into the gap between door and frame
  2. Read the measurement where the gauge meets resistance
  3. Check all four edges — gaps can vary around the door
  4. Record measurements for each door inspected

Common Causes of Excessive Gaps

  • Building settlement — frames shift over time
  • Door warping — caused by humidity or temperature changes
  • Poor original installation — frame not plumb or square
  • Hinge wear — causing the door to drop

Remedial Solutions

Depending on the cause, gaps can be corrected by:

  • Adjusting hinges — repositioning to close gaps
  • Fitting intumescent edge strips — adding sealing capability
  • Planing the door — reducing gaps on the tight side (only if within tolerances)
  • Replacing the frame — if the frame has moved significantly
  • Full door replacement — when the door has warped beyond correction

Our Inspection Process

Stark Contracts' BM TRADA certified inspectors measure every gap on every door during our surveys. Our reports include exact measurements, photographic evidence, and prioritised remedial recommendations.

Book a fire door gap inspection — call 01522 775570 or email Enquiries@Starkcontracts.co.uk.